resetting control panel whirlpool refrigerator wrs325sdhz01

The only time it is safe to unplug a refrigerator is when you are servicing or cleaning it and you need it to be completely off. In fact, unplugging a refrigerator can affect the internal temperature and cause the food inside to spoil. No, unplugging a refrigerator will not reset it. If this does not reset the unit, or you see any error codes, it is recommended that you refer to your owner’s manual or contact Whirlpool’s customer service hotline for assistance. Turn the thermostat to the coldest setting, then turn it back to the desired setting. Plug the cord back in and wait 30 secondsģ. Unplug the power cord from the wall outlet and wait 30 secondsĢ. To reset your Whirlpool side by side freezer, you will need to do the following:ġ. How do you reset a Whirlpool side by side freezer? If the reset does not work, follow additional troubleshooting tips. If the reset button is not accessible, then you need to find the thermal cut-off switch and press it for 5 to 10 seconds. You can also see the reset button behind the lower grille of the refrigerator, located at the bottom. If it is the gray or grayish-black button, then you need to press the button for 5–10 seconds. Depending on the model, you might have either a red button or a squared gray or grayish-black button. The reset button on a Whirlpool side by side refrigerator is located at the back and lower end of the refrigerator. Where is the reset button on a Whirlpool side by side? If the issue persists, you may need to replace the control board.

If the light is flashing, unplug the refrigerator from the wall outlet, wait 2 minutes and then plug it back in.Īfter the refrigerator is plugged back in, hold down the “Energy Saver and Lock” buttons for 10 seconds until the LED light is no longer flashing. If this does not work, use a flashlight to check the LED light on the inside of the control board. This should reset the control board and return the refrigerator to normal operation. After the refrigerator is plugged back in, press and hold the “Energy Saver and Lock” buttons simultaneously for 10 seconds until the “Idle” light appears. Leave the refrigerator unplugged for 2 minutes and then plug it back in. To reset the Whirlpool refrigerator control board, first unplug the refrigerator from the wall outlet.

Resetting control panel whirlpool refrigerator wrs325sdhz01